Jandy LRZ Electronic - 7.4 User Setup Options; 7.5 Set Point Lockout

Page 28
ENGLISH
Jandy
®
Legacy™ Model LRZE Pool/Spa Heater by Zodiac
®
|
Installation and Operation Manual
 
The User Setup options allow the user to select
specic Languages, Temperature Scale, Spa Timer,
and Display Light options.
 
1. Make sure the control is in the  mode.
2. To enter the User Setup mode, press and hold the
 button for 5 seconds.
 Thedisplaywillrevertbacktoafterone
minutesincethelastkeypress.
3. To select a language, use the  or 
button to display


. Press the  button. The
 (default
language) appears, use the
 or  button
to scroll through the language options. When
you reach the desired language, press the

button to select the language. Press
 or
to exit the User Setup mode.
 
1. Make sure the control is in the  mode.
2. To enter the User Setup mode, press and hold the
 button for 5 seconds.
3. To select temperature scale, use the
 or 
button to scroll through to display 

. Press
the button. The 

(default temperature scale) appears, use the
 or  button to scroll to display 

.When you reach the desired
temp scale, press thebutton to select.
Press  or  to exit the User Setup mode.
 
1. Make sure the control is in the  mode.
2. To enter the User Setup mode, press and hold the
 button for 5 seconds.
3. To select spa timer, use the
 or  button
to scroll through to display 

.Press the  button.
The 
(default spa timer setting)is displayed. To turn
the spa on or off indenitely, press the 
button to select.
To select the length of time for the spa to run,
use the
 or  button to scroll to display
.
Press thebutton to select.The display
(default time
setting) is displayed. Use the  or  button
to select the length of time for the spa to run
(between 00:15 to 23:00 hours incremented by
00:15 minutes). Press the  button to select
how long the spa will run. Press  or 
to exit the User Setup mode.
 
1. Make sure the control is in the  mode.
2. To enter the User Setup mode, press and hold the
 button for 5 seconds.
3. To select display light setup, use the
 or 
button to scroll through to display 

. Press the
 button. The 

(default display light setting)is
displayed. This option allows the display light to
turn off after 2 minutes. Press thebutton
to select. Use the  or  button to scroll
to display 

, this option allows the display light to turn
off, press thebutton to select. Use the 
or  button to scroll to display 

,this option allows
the display light to turn on, press the
button to select. Press  or  to exit the
User Setup mode.
 
Make sure the control is in the  mode (
or ), press and hold the  and  buttons for
5 seconds. The set point will be locked and the control
will operate in the mode it was in when the Set Point
Lockout occurred. If an attempt to change the set point
is made while the control is in Set Point Lockout,
the control will display
. To
unlock the Set Point Lockout, press and hold the

and
buttons for 5 seconds. The unit will display
.