Janome DC5100 - Winding the Bobbin

SEWING MACHINE
2
MODEL DC5100
(1)
(2)
(3)
(4)
(2)
(A)
(3)
(B)
10
1/8
3/8
5/8
(4)
(1)
WINDING THE BOBBIN
(1) PASS THE THREAD AROUND THREAD GUIDE.
(2) THEN THROUGH THE HOLE IN THE BOBBIN.
(3) PUT THE BOBBIN ON THE BOBBIN WINDER SPINDLE, AND PUSH THE BOBBIN TO THE RIGHT.
(4) WHEN THE BOBBIN IS FULLY WOUND, IT WILL STOP AUTOMATICALLY. RETURN THE BOBBIN
WINDER TO ITS ORIGINAL POSITION BY MOVING THE SPINDLE TO THE LEFT, AND CUT THE
THREAD AS SHOWN.
INSERTING THE BOBBIN
PLACE THE BOBBIN IN THE BOBBIN HOLDER WITH THE
THREAD RUNNING OFF IN THE COUNTERCLOCKWISE.
(1) END OF THREAD
GUIDE THE THREAD INTO THE NOTCH (A) ON THE FRONT
SIDE OF THE BOBBIN HOLDER.
DRAW THE THREAD TO THE LEFT, SLIDING IT BETWEEN THE
TENSION SPRING BLADES.
(2) NOTCH (A)
CONTINUE TO DRAW THE THREAD LIGHTLY UNTIL THE
THREAD SLIPS INTO NOTCH (B).
PULL OUT ABOUT 15 CM (6") OF THREAD.
(3) NOTCH (B)
ATTACH THE HOOK COVER PLATE.
CHECK THE THREADING BY REFERRING TO THE CHART
SHOWN ON THE HOOK COVER PLATE.
(4) THREADING CHART