39
SEWING MACHINE MODEL DC5100
TO REMOVE:
1. REMOVE THE FRONT AND REAR COVER.
2. REMOVE THE TWO SETSCREWS (A) AND REMOVE THE ZIGZAG WIDTH MOTOR PROTECTOR
PLATE. CUT THE BINDER.
3. REMOVE THE TWO ZIGZAG ROD SETSCREWS (B).
4. REMOVE THE TWO SETSCREWS (C) AND REMOVE THE ZIGZAG WIDTH MOTOR.
TO INSTALL:
5. TO INSTALL THE ZIGZAG WIDTH MOTOR, FOLLOW THE ABOVE PROCEDURE IN REVERSE.
NOTE:
1. THE SETSCREW OF ZIGZAG ROD SHOULD BE TIGHTENED TO 5~7 KGF OF TORQUE.
2. CHECK TO ENSURE THAT THE UPPER SHAFT SENSOR MOUNTED ON THE ZIGZAG WIDTH
MOTOR DOES NOT INTERFERE WITH THE UPPER SHAFT SHIELD PLATE.
3. ADJUST THE NEEDLE DROP POSITION (SEE PAGE 19).
REPLACING THE ZIGZAG WIDTH MOTOR
SETSCREW (A)
SETSCREW (A)
ZIGZAG WIDTH MOTOR
PROTECTOR PLATE
BINDER
2 SETSCREW (B)
ZIGZAG WIDTH SETSCREW (B)
SETSCREW (C)
SETSCREW (C)
ZIGZAG WIDTH
MOTOR
ZIGZAG WIDTH
MOTOR
To Next Page
Loading...
