Janome DC5100 - Replacing the Feed Stitch Motor

40
SEWING MACHINE MODEL DC5100
TO REMOVE:
1.REMOVE THE FRONT COVER AND REAR COVERS (SEE PAGE 15 AND 16)
2.REMOVE THE SNAP RING (E-3)
3.REMOVE THE TWO SETSCREWS AND REMOVE THE FEED MOTOR.
CUT OFF THE CORD BINDER.
TO INSTALL:
TO INSTALL THE FEED MOTOR, FOLLOW THE ABOVE PROCEDURE IN
REVERSE.
NOTE:
ADJUST THE STRETCH STITCH PATTERNS (SEE PAGE 26).
REPLACING THE FEED STITCH MOTOR
SNAP RING (E-3)
SNAP RING
(E-3)
FEED MOTOR
SETSCREW (A)
SETSCREW (B)
BINDER
ACCESS SETSCREW (B)
THROUGH THIS HOLE