Janome DC5100 - Threading the Machine

SEWING MACHINE
3
MODEL DC5100
1
3
(1)
(3)
(4)
(5)
(6)
THREADING THE MACHINE
RAISE THE PRESSER FOOT LIFTER, AND PASS THE THREAD THROUGH POINTS (1) TO (6).
(1) HOLD THE UPPER THREAD AND PASS THE THREAD UNDER THE THREAD GUIDE. PULL THE
THREAD DOWN ALONG THE RIGHT CHANNEL.
(2) DRAW THE THREAD AROUND THE CHECK SPRING HOLDER FROM RIGHT TO LEFT, THEN
PULL UP THE THREAD.
(3) FIRMLY DRAW THE THREAD FROM RIGHT TO LEFT AND PULL IT TOWARD YOU INTO THE
EYE OF THE THREAD TAKE-UP LEVER, THEN DOWN TO THE LOWER THREAD GUIDE.
(4) DRAW THE THREAD FROM RIGHT TO LEFT BEHIND THE LOWER THREAD GUIDE.
(5) SLIDE THE THREAD BEHIND THE NEEDLE BAR THREAD GUIDE FROM THE LEFT.
(6) THREAD THE NEEDLE FROM FRONT TO BACK USING THE NEEDLE THREADER.
(2)
(4)