Janome DC5100 - Replacing Transformer

38
SEWING MACHINE MODEL DC5100
TO REMOVE:
1.REMOVE THE FRONT COVER
2.REMOVE THE TWO SETSCREWS AND REMOVE THE TRANSFORMER.
TO INSTALL:
3.TO INSTALL THE TRANSFORMER, FOLLOW THE ABOVE PROCEDURE IN REVERSE
NOTE:
PLACE THE REAR END OF THE TRANSFORMER ON THE TRANSFORMER SUPPORT.
SLIDE THE TWO TRANSFORMER WIRE TUBES TO THE SIDE OF TRANSFORMER AND SECURE THEM TO
THE ZIGZAG STEPPING MOTOR WIRE SO THEY WILL NOT COME IN CONTACT ANY MOVING PARTS.
TRANSFORMER
SETSCREW
REPLACING TRANSFORMER
SETSCREW