q
e
r
t
w
y
Adjusting Height of Embroidery Foot P
The space between the needle plate and the bottom surface of the Foot P should be 0.7 to 1.5
mm, when the needle bar is at its lowest position.
1. Remove the top cover.
2. Lower the needle bar and lower the presser
foot lifter. Set the pressure dial to 2
q .
3. Insert the 1.2 mm thickness gauge between
the Embroidery Foot P
w and the needle plate.
4. While pressing the Presser Bar Actuator
e
down against the upper shaft cam, loosen
Screw
r and tighten it again.
5. Chech that the space is set between
0.7 - 1.5 mm
t .
6. Reattach the top cover.
q
Presser Dial
w Embroidery Foot P
e Presser Bar Actuator
r Screw
t Space 0.7 - 1.5mm
y Lowest Needle Position
Note: After adjusting the Embroidery Foot P w
height, make sure to adjust the presser
Foot sensor (see page 27).
20
To Next Page
Loading...
