w
q
t
e
r
y
Replacing Needle Threader Unit (1)
Replacing the needle threader motor (unit) when the bottom (threader carriage) switch is
defective.
To remove:
1. Removing the face cover
Remove the screws A
q (2 pieces) and remove
the face cover
w.
q
Screws A
w Face Cover
2. Remove the front panel
(Refer to page 21 to 22)
Remove each cord e, r from the 2 cord
guides
t.
e
Micro Switch Cord (2 pieces)
r Motor Cord, Lamp Cord
t Cord Guides
3. Removing the needle threader motor (unit)
Remove Screw B (2 pieces)
y and remove the
needle threader motor (unit).
y Screws B
34
To Next Page
Loading...
