q
e
re
y
w
t
Replacing Slide Volume / Printed Circuit Board F
To replace the slide volume and printed circuit board F, follow the instructions below.
Replacing the slide volume
To remove:
1. Remove the front cover unit.
2. Pull out the slide volume connector
q from the printed circuit board F w.
3. Remove the CS rings 3 (2 pieces)
e
and the slide volume r .
Printed circuit board F
To remove:
1. Remove the front cover.
2. Pull out the connector from the
printed circuit board A and the slide
volume connector
q .
3. Remove screws (3 pieces)
t and a
CS ring 3
e , then remove the printed
circuit board F
w .
To attach:
4. Follow the above procedure in
reverse.
q
Slide Volume Connectors
w Printed Circuit Board F
e CS Ring 3 for Slide Volume
r Slide Volume
t Screws (3 pieces)
y F Board Connector
25
To Next Page
Loading...
