e
y
t
r
q
w
Adjusting X Motor Gear
If the X-motor gear sound is noisy when sewing the embroidery stitches, follow the
instructions below.
To remove:
1. Remove the base unit (see page 5).
2. Remove the presser foot.
3. Remove screw A q and nylon clip w .
4. Attach the X and Y motor connectors to PC
board A.
5. Turn the Power ON and select
Monogramming in the Embroidery Mode.
6. Select large “A” in Gothic style and
memorize it 3 times.
7. Lower the presser bar.
8. Insert a piece of paper
e between the
thread tension discs as shown so that the
needle thread sensor will not work.
9. Run the machine and loosen screws B
r
(2 pieces) and move the X-motor t to
detect the quietest position, while the
carriage is moving in lateral direction then
tighten the screws
r .
10. Return the carriage to the home position
and turn the Power OFF.
11. Pull the X and Y motor connectors and
secure the nylon grip with screw A.
12. Reattach the base unit.
q
Screw A
w Nylon Clip
e Insert the Piece of Paper
r Screws B (2 pieces)
t X-Motor
y Adjust the Carriage Position when it moves in
the Direction of the Arrow
39
To Next Page
Loading...
