A = B
q
w
e
r
t
t
1. Remove the top cover, and select the pattern
No.1 (Straight stitch) and lower the needle to
its lowest position by turning the handwheel.
2. Loosen screw
q , move the zigzag width
connecting rod
w to the right or left until the
needle comes to the center of the needle plate
hole
e .
3. Select the pattern No.8 (Zigzag) and set the
zigzag width at 7.0 mm.
4. Turn the handwheel toward you and check the
clearance at the outside of both the left and
right sides. It should be 0.2 mm or more
t as
shown below.
5. Reattach the top cover.
q
Screw
w Zigzag Width Connecting Rod
e Needle Plate Hole
r Needle # 14
t 0.2 mm or more
Adjusting Needle Drop Position
When the straight stitch is selected on the touch panel, the needle should be positioned at the
center of the needle plate hole and when the maximum zigzag width ( 7 mm) is selected, the
standard clearance at the outside of both the left and right sides should be 0.2 mm or more as
shown below.
7
To Next Page
Loading...
