q
q
w
r
t
e
y
Adjusting Needle Threader Switch
Adjust the upper switch position as follows if the instructional display will not disappear.
1. Remove screws A
q ( 2 pieces) and remove
the motor cover
w.
q
Screws A (2 pieces)
w Motor Cover
2. Loosen screw e and adjust the position of
switch
r position by moving it up or down, so
that the needle threader stops with a 3 mm
gap
t between the slider y and the top end
of the guide slot.
e
Screw B
r Slider
t Approximately 3 mm Gap
y Switch
3. Attach the motor cover with Screws A.
36
To Next Page
Loading...
