To attach:
1. Insert the convex of the threader guide
q
into the forked part of the threader carriage
w.
q
Convex of the Threader Carriage
w Threader Guide
2. Attach the needle threader motor (unit) with
Screws B
e.
Tighten the screws while pressing the needle
threader motor (unit) to the back.
e
Screws B
3. Press the needle threader button and check
the movement.
r Cord guide
t Micro-switch Cord (2 peices)
y Moter Cord & Lamp Cord
Replacing Needle Threader Unit (2)
r
t
y
q
w
e
e
35
To Next Page
Loading...
