q
e
r
w
w
t
Replacing Carriage Plate (Unit)
Replace the carriage plate
To remove:
1. Turn the Power ON and select the Embroidery
Mode on the touch panel.
Select pattern #1.
2. Turn the Power OFF and remove the cover
cap
q.
(Unlock the hook from the inside.)
3. Turn the Power ON and return the carriage to
the home position.
4. Remove screws (3 pieces)
w and remove the
carriage plate (unit).
To attach:
5. Attach the carriage plate (unit) with tightening
screws temporarily.
6. After the top surface of the carriage plate and
the arm surface are parallel and the same
level, securely tighten the screws.
7. Attach the cover cap
q.
q Cover Cap
w Screws
e Hook
r Drop Plate
t Arm Surface
32
To Next Page
Loading...
