Jayco Seismic 2021 -

136


The following information details the functions of the utility center water valves as dis-
played on the valve operation label:

1. Connect the fresh water hose to the City water connection inlet on the utility center.
2. Set the color coded valves to POWER FILL TANK setting:
 (A) White handle pointing right
 (B) Blue handle pointing left
 (C) Black handle pointing right
 (D) Red handle pointing up
 (E) Green handle pointing right
3. Connect the other end of the hose to a pressurized fresh water source (faucet or spigot).
4. Turn the pressurized water source ON, the tank should begin lling.
5. When water has reached the desired level, turn the pressurized water source OFF.
6. Disconnect water source from the spigot/faucet rst, then disconnect from the city wa-
ter ll inlet on the utility center. 

1. Connect a garden hose to the city water inlet (do not use your fresh water hose to sani-
tize the water lines or the tank).
2. Set the colored coded valves to the SANITIZE setting:
 (A) White handle pointing down
 (B) Blue handle pointing down
 (C) Black handle pointing right
 (D) Red handle pointing left
 (E) Green handle pointing right
 The water heater is automatically bypassed on this setting.
A check valve is located inside the city water connection inlet on the utility
center.        
 It will cause irreparable damage to the
valve function and the inlet will leak water.

 Refer to the Sanitizing Plumbing System section before starting
this process.