60
Depending on your model, the spare tire may have (side or bottom) brackets or it will be
mounted against the underside of the recreation vehicle (ush mount) to give it stability in
travel.
The crank handle to raise and lower the tire will be located (fastened to the sidewall) in a
basement compartment of the recreational vehicle. Insert the crank handle into the crank
access port located either in the center of the rear bumper, or on the sidewall of the RV. Turn
the crank handle to raise/lower the tire. Two “crisp breaks” must be heard and felt to insure
the proper seating of the tire for travel.
To secure the spare tire in the travel position, put the steel hoist lift support located on the
end of the cable through the rim of the tire. The hoist lift support clips need to seat inside
the center hole of the tire rim. The valve stem of the tire MUST be pointed up (toward the
bottom of the RV).
The spare tire bracket can be released and extended down to access a storage compartment
at the rear of the trailer without removing the tire.
If your spare tire is a ush mount application, it must make contact
with the underside of the recreational vehicle to insure maximum road clear-
ance and stability in travel. Raising and lowering the hoist
If the manual crank access port is
located in a slideout, the slideout room must be in
the travel position to allow the crank to reach the
mechanism used to raise or lower the tire.
To Next Page
Loading...
