Jayco Seismic 2021 - GFCI Receptacle

91

GFCI Receptacle
There is a ground fault current interrupter (GFCI) engineered into the electrical system.
It is designed to reduce the possible injury caused by electric shock. The GFCI will not
protect against short circuits or circuit overloads.

 Push in the GFCI “TEST” button. The GFCI “RESET” button should pop out
indicating the GFCI receptacle has been “tripped” and interrupted 120-volt power.
 Push in the GFCI “RESET” button to restore 120-volt power.
Contact your independent dealer for assistance if the GFCI “RESET” button does not
restore 120-volt power and pops back out.
A “tripped” GFCI breaker indicates that abnormally high 120-volt current ow (a
ground fault) was detected. All ground faults must be repaired before use of the recre-
ation vehicle. If the GFCI “RESET” button does not restore 120-volt power and pops
back out. Contact your dealer for assistance.
Command Control System (if so equipped)
The Command Control System is a name given to encompass several dierent types of
Bluetooth controlled systems now being used in Jayco and Highland Ridge towable RVs.
Examples of Bluetooth controlled systems currently in use are listed below.
The Command Control System is capable of controlling some or all of the following features
depending on the Bluetooth system and RV model:
RV Auto Leveling System Power Jacks and Stabilizers
Interior and Exterior Lighting RV Slide out rooms
Power awnings Generator
TV and bed lifts HVAC thermostat
Gas and Electric water heaters Water tank levels (Blk, Gry, Fresh)
Battery levels Back up camera sysems
Water Pump Kitchen & bath vents and covers
Door locks TV, radio and DVD systems
Automatic Fireplace control Automatic ramp door (toyhauler)
Smartsense Propane Sensor Smarttemp Temperature Sensor

Current Bluetooth systems in use that fall under the Command Control System would in-
clude:
  uses the LCI One Control App (for phone or tablet) (Apple/
Android)
  uses the LCI One Control App (for phone or tablet
(Apple/Android)
  touchscreen system (with its own dedicated App RV-
Genius for Apple/Android)
 control system (uses the JayCommand App
for Apple/Android)
  touchscreen system (with a leveling system installed)
Check the  in this manual to identify your Bluetooth system and more
specic information on system operation.