66
1. Load the cargo bay from front to back, keeping heavier vehicles/items to the front of
the cargo bay area.
2. Load all vehicles/equipment evenly from side to side in the cargo bay.
3. Secure all vehicles/items to prevent load shifts during transit.
4. After loading, weigh the trailer at the hitch, each axle, and each wheel. Observe all
trailer gross, axle, and tire ratings.
5. If the weight of the loaded trailer exceeds any of the ratings as listed on the certication
label located on the front lower left outside wall, remove or re-distribute the cargo load
until the weight(s) are less than the maximum ratings.
Typically (2) air vents are located in either side of the cargo bay and are designed for airow
and ventilation when there is fuel powered equipment in the cargo bay.
To open the vent(s), rmly grasp the vertical bar in the middle of the vent, and push or pull it
to the left or right until it clears the notch in the pivot base as shown below and the vent will
open. To close it, pull the handle until it returns to the center of the pivot base.
Both vents should be open to prevent gas fumes from building up
in the recreation vehicle. The upper vent should be positioned to draw air
into the unit, and the lower to direct the air out when the unit is in motion.
To Next Page
Loading...
