72
Each power awning will have its own control switch; press
and hold to extend or retract.
Rear side awning (if so equipped) switch is typi-
cally located in the cargo bay area.
Front side awning (if so equipped) switch is typi-
cally located on the living area wall.
Rear patio awning (if so equipped) can be either
manual or power. The power awning is controlled
by a single channel remote mounted to the wall in-
side the rear entrance door.
1. Press the UP and DOWN buttons simultaneously until the motor
jogs. Note: after every command the motor will jog to conrm.
2. Check the direction of rotation with the UP or DOWN button. If
needed, change the direction of rotation by pressing and holding
the STOP button until the motor jogs.
3. Press and hold the PROGRAM button on the back of the transmit-
ter until the motor jogs. The buttons no longer have to be held
for the motor to run. Double check the limits are in the desired
position.
4. To reset the motor to factory mode, start with the motor connected
to power. Cut the power for 8 seconds, reconnect the power for 8
seconds, cut the power for 8 seconds and reconnect the power. The motor should start
to run (if this does not happen repeat the 8 second power cuts until the motor does run).
Allow the motor to stop on its own (do not press stop, up or down or you will have
to repeat the double power cut). Once the motor stops on its own, press and hold the
programming button for over 8 seconds. The motor should jog twice.
If your RV is equipped with a touch screen control system, the
awning controls may be found on the touch screen.
To Next Page
Loading...
