26
4. Working with the woodchipper
Schematic display, differences in design and type possible.
4.4.5 Setting up the infeed chute into work position
1. Depending on the model push the handle of the infeed flap or pull up the lock
and turn it around 180° until it latches.
2. Lower the infeed flap into the work position.
3. Secure the flap by latching or by using the infeed flap lock again (turn it back
180° until it locks in the designated hole).
Attention!
Hold on to the flap when lowering it, so it does not drop down. Danger of injuries!
4.4.6 Setting up the infeed flap into transport position
Proceed in reverse order to 4.4.5.
Attention!
Check for the infeed flap lock to be locked before driving so it cannot drop down.
manual
safety
interru
tion
To Next Page
Loading...
