40
5. Operation and maintenance devices
The engine should not be switched off during the regeneration
process or only in emergencies, so that the regeneration can be
completed properly.
As long as an error code is displayed on the HCflex, no automatic
regeneration is possible!
If automatic regeneration is required, this is displayed or requested
on the HCflex
seeFi
ure 7
.
If you confirm with "OK" you switch back to the standard operating display, where
additional information is now displayed. In addition, the DPF symbol appears and the
indication that the motor should not be switched off during regeneration, and the feeder
can be activated despite regeneration.
5.7.1.3.6 Parked regeneration:
Regeneration at a standstill means that during regeneration the feed is deactivated
and therefore it is not possible to work with the machine. Only when the regeneration
has been successfully completed can the machine be used as usual. This type of
regeneration can take up to 30 minutes. Regeneration at a standstill is always
necessary if automatic regeneration has been suppressed for too long. In addition, it
is necessary that regeneration is carried out at a standstill at certain intervals, even if
automatic regeneration has been carried out regularly. If regeneration is necessary at
a standstill, the following window appears.
Figure 8: Display automatic regeneration
To Next Page
Loading...
