Jensen A540 - Page 61

43
5. Operation and maintenance devices
5.7.1.3.8 Speeds on the chipper disc
5.7.1.3.9 Hours
5.7.1.3.10 Motorparameter
If this speed falls below this speed, the feeder is
deactivated and the retraction is briefly activated
for the set retraction time.
If this speed is exceeded, the feeder is reactivated
if it has been deactivated due to a fall below the
minimum speed.
After exceeding this speed, after the machine
start, the feeder can be activated.
If this speed is exceeded, the feeder is
deactivated.
Dail
y
operatin
g
hours
Displa
y
of total operatin
g
hours
Chipper total operatin
g
hours
Service interval
Software version
Displa
y
of en
g
ine oil pressure [bar]
Display of the coolant temperature of the engine
[°C]
Displa
y
of the applied operatin
g
volta
g
e [V]
Display of the current engine power [%]
Temperature of exhaust
g
ases
Figure 13- Chipper disc speeds
Figure 14: Operating hours display on the HCflex
Figure 15: Motor parameters on the HCflex