Jensen JHD36A - SATELLITE SIGNAL AND CHANNEL LOCK; Signal Strength Indicator; SiriusXM Channel Lock Management

tiHib
,
JHD36A
HEAVYDUTY
--------------------------------------------------------------------------------------------------------------------
Satellite
Signal
Strength
The display will Indicate satellite
reception strength
as
shown
below.
Signal
Strength Strength Display
No
Signal
YX
Weak
Y.
Good
Y.a
Excellent
Y.tl
Channel
Lock
Access
Channel
Lock through the System Menu under the
"SiriusXM Satellite Radio"
menu.
See
"System Menu"
on
page
6.
1.
Select "Set
Lock Code" and press the
INFO/ENTER
button (16).
2.
Enter the
default lock
code of
"0000".
To
set the lock
code:
a.
Press
the
TUNE/SEEKI<<
or
>>1
(18, 19) buttons to enter the first digit of the
default
code.
b.
Press
the
INFO/ENTER
button to move to the next digit.
c.
Repeat above steps to enter
all
4 digits of the
default code.
d.
Press
the
TUNE/SEEKI<<
or
>>1
buttons to enter the first digit of the new code.
e.
Press
the
INFO/ENTER
button to move to the next digit.
f.
Repeat above steps to enter
all
4 digits.
g.
Repeat above steps to confirm the new code.
3.
After setting a new four digit code, you can
lock channels
by entering the
"Locked
Channels" menu.
4.
Upon entering the Locked
Channels list,
you
will
be prompted to enter your four digit code.
a.
Press
the
TUNE/SEEKI<<
or
>>I
buttons to enter the first digit.
b.
Press
the
INFO/ENTER
button to move to the next digit.
c.
Repeat above steps to enter
all
4 digits.
5.
After entering the code, you can navigate the
list
using the
TUNE/SEEKI<<
or
>>1
buttons
to highlight
the
channels.
6.
Press
the
INFO/ENTER
button to Lock, indicated by
a(@),
or Unlock
(
{j;)
the
selected
channel.
12
Reset
SiriusXM
Channel
Lock
Code
If you forget your
Parental Control lock
code, use the following
directions to reset the code to the
default "0000". Resetting the
lock
code
will
not affect the locked channels list.
1.
In
SirlusXM mode, tune to
Channel 0
2.
Set volume
to
0.
3.
Press
and
hold
the rotary encoder
(1)
to power off the unit.
4. With power off,
press
and
hold
the rotary encoder
until
the system version info
is
displayed
on
the screen
5.
Press
the
3/RDM
button
(5),
the screen
will
return to the
clock.
6.
Press
the rotary encoder to power
on
the unit.
7.
The
lock code has now been reset to
"0000"