Jensen JHD36A - SPECIFICATIONS; Technical Data and FCC Compliance

t
liKiD
j
HUVYD~
--------------------------------------------------------------------------------------_:JH~D~36=A~
SPECIFICATIONS
USB
Signal
to Noise Ratio
................
.
...................
.
.........
.
........
> 65 dB
Channel
Separation
...
.
.....
.
............
.
.........
.
........
...
.....
More than
50
dB
Frequency Response . .
...........................
.
..................
20
Hz -
20 kHz
FM Radio
Frequency Coverage
(USA)
................
.
........................
87.5 to 107.9 MHz
Frequency Coverage (Europe)
.......................................
87.5 to
108
MHz
Sensitivity
(S/N
= 30dB)
......................................................
2.2
1
.JV
Stereo Separation
...
.
...............
.
...
.
.................................
>25 dB
AMIMW
Frequency Range (USA)
..
.
...
..
. . .
..
. . . . . . . . . . .
..
...
.. .. .. ..
. . .
...
. . . .
530-1710
kHz
Frequency Range (Europe)
...............
.
.............................
522-1620 kHz
Sensitivity (S/N=20dB)
.....................................................
30
dB
General
Frequency band(s) (for
Bluetooth)
......................................
2.4-2.4835GHz
Maximum radio-frequency power transmitted (for
Bluetooth)
..........
.
..............
4 dBm
Operating Voltage
.
...................
.
..
.
...................
.
.........
DC 12
Volts
Grounding System .
............
.
........
..
............
..
.....
.
.....
Negative Ground
Speaker
Impedance
. .
.................
.
....................
. . 4-8 ohms per channel
Tone
Controls:
Bass (at
100Hz)
........................................................
±10 dB
Treble (at
10kHz)
.
..................
. . .
...................
.
.............
±1
0
dB
Power
Output
....
.
.....................
.
..................
. . .
..........
45W x 4
Idle/
Standby Current .
........................................................
o
A
Current Drain
.......
.
..........
.
.........
.
..........
.
...............
15 Ampere Max
Dimensions
..............
.
.....
.
.............
.
.....
.
......
175
(W)
x 175 (D) x
50
(H)
19
FCC
Notes
WARNING! Changes
or
modifications
to
this
unit
not
expressly
approved
by
the
party
responsible
for
compliance
could
void
the
user's
authority
to
operate
the
equipment.
NOTE: This
equipment
has been tested
and
found
to
comply
with
the
limits
for
a
Class 8
digital
device,
pursuant
to
Part
15
of
the FCC Rules. These
limits
are
designed
to
provide
reasonable
protection
against
harmful
interference
in
a
residential
installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed
and
used in accordance with the instructions, may cause
harmful
interference to radio
communications.
However, there is no guarantee that interference
will
not occur in a
particular installation. If
this
equipment does cause
harmful
interference to radio or television
reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of
the
following
measures:
Reorient or
relocate
the receiving antenna.
Increase
the separation between the equipment and receiver.
Connect the equipment into an
outlet
on a circuit different from that to which the receiver is
connected.
Consult
the
dealer
or an experienced radio/ TV technician for help.