M
Ingenieurbüro CAT, M. Zipperer GmbH +49-7634-5056-800
Wettelbrunner Straße 6 sales@jetcat.de
57 79282 Ballrechten-Dottingen www.jetcat.de
GERMANY
AUX-channel func The AUX-channel (3-step switch) can be used for optionally special features or disabled
even for single-channel operation.
ON,TrbCtrl ON:
Aux channel enabled for engine control
ON.TrbCtrl OFF:
Aux channel enabled for additional functions like speed limiter functions, Smoker
control etc.
Turbine control disabled. The Aux channel is used only for additional control
functions. The engine control is only via the throttle channel ( Single Channel Mode)
NOT USED:
Single Channel Mode.
Totally disabled AUX channel input for engine control, speed sensor and smoker
functions. AUX channel wire must not be connected to the receiver in this mode. In
case of a connected air-speed sensor the Maximum Limit Speed is still active and
limits the maximum speed of the plane. This safety function can’t be disabled.
AUX-SW0 Action Only if the parameter “AUX-channel func” (see above) has been set to “ON, TrbCtrl OFF”
this option is visible. In this case, the AUX-channel (3-step switch) can be used for
optional controls or can be disabled.
This option defines the action taken if the 3-step switch is be set to the “SW0” position
(backwards position)
DISABLED/NONE
No Action
LowIdle active
Idle rpm will be reduced to the value set by the “LowIdleRpm” parameter
Turbine-OFF
The following options are only present with an airspeed sensor connected:
LrnSpeed Lo/Hi
LrnSpeed Lo
LrnSpeed Hi
Hold-Speed
AUX-SW2 Action Only if the parameter “AUX-channel func” has been set to “ON, TrbCtrl OFF” this option
is visible. In this case, the AUX-channel (3-step switch) can be used for optional special
controls or be disabled.
This option defines the action taken if the 3-step switch is be set to the “SW2” position
(forward position)
DISABLED/NONE
No Action
LowIdle active
Idle rpm will be reduced to the value set with the “LowIdleRpm” parameter
The following options are only present with an airspeed sensor connected:
To Next Page
Loading...
