JETSURF ELECTRIC - 5. Controls; 5.1. Control Handle

23
5. CONTROLS
5 CONTROLS
5.1. CONTROL HANDLE
The motorized surf is supplied with the control handle which controls the motor output. The
handle is supplied together with the engine shut-off key which is used for the motorized
surf activation.
Warning (Risk of Injury)
The motor shut-off key must be attached to the rider’s wrist during the operation. If
the rider falls off or is pushed off the motorized surf, the key will be pulled out of the
engine shut-off switch and the motor will switch off automatically.
Caution
The engine shut-o key must be securely fastened around the rider‘s wrist by wrist
band on the hand in which the rider holds the handle.
1
Engine shut-o switch
2
Throttle trigger
3
Engine shut-o key
Info
The throttle trigger is situated on the handle, at the end of the throttle cable. JetSurf
recommends controlling the throttle with your index nger.
When the throttle trigger
is pressed, you increase the revs, when it is released, you decrease the revs.
5.1.1. BOOSTER
The control handle of the JetSurf Electric has a
function Booster that is activated when the throttle
trigger
A
is fully pressed (going a bit against the
resistance) and gives the user maximum power of
the electric motor.
Info
When using this function frequently, it could be temporarily deactivated to prevent
overheating off electric motor.
2
3
1
A
JE_0501
JE_0502