JETSURF ELECTRIC - Main Fin Fastening

41
8. BEFORE THE RIDE
8.3.3. MAIN FIN FASTENING
• Unscrew 4 (four) screws from the Main n
base.
4 x screw M6x12
Info
Use the screwdriver provided with the JetSurf Electric.
• Place the main n on the Main n base.
Note
Make sure the n is oriented correctly.
• Insert the removed screws in the openings on
the main n and tighten the n.
Tightening torque 3,5 N.m
Note (Material damage)
Tighten gently. If too tight, the n can be damaged.
Info
The n should not allow any movement.
Note (Material damage)
• Do not transport a motorized surf with ns attached. The ns are fragile and are
not designed to bear the weight of a surfboard on a hard surface.
• Keep all the screws openings for attaching ns clean, without sand and other
impurities which might damage the thread.
• We recommend screwing the main n screws into the base even without the n.
JE_0812
JE_0813