JETSURF ELECTRIC - Check for Water Presence in the Motor Compartment; Rinsing; Lubricating of the Central Bearing of the Jet Pump

53
9. RIDING INSTRUCTIONS
Note (Material damage)
Never forget to get all the remaining water out of the cooling system after the ride.
Otherwise there is a risk of permanent damage to the battery, connector and regulator.
9.12.3. CHECK FOR WATER PRESENCE IN THE MOTOR COMPARTMENT
• Check out through the inspection cover whether there is not any water at the bottom of the
motor compartment . ( p.43)
Info
If it is the case, contact your authorised JetSurf sales representative as soon as possible.
Caution (Risk of Injury)
Before the check, always make sure that the battery has been removed from the
JetSurf Electric You will thus avoid a possible electrical injury.
9.12.4. RINSING
If you want to store the board overnight, nd a source of fresh water, e.g. a garden hose, and
rinse:
• the top part of the board, straps, control handle and jet pump
• after removing the battery and putting the battery connector cover on the JetSurf
Electric, rinse the battery compartment area as well.
Note (Material damage)
If the motorized surf was used in seawater or brackish water, rinse the cooling system
with fresh water ( p. 30).
Note (Material damage)
Never forget to place the connector cover on the Jetsurf Electric before rinsing the
battery compartment
9.12.5. LUBRICATING OF THE CENTRAL BEARING OF THE JET PUMP
• Remove 4 (four) socket head screws on the
motor cover.
4 x screw M6x12
Tightening torque 3,5 N.m
JE_0814