52
9. RIDING INSTRUCTIONS
9.12. AFTER THE RIDE
9.12.1. A BRIEF LIST OF THE TASKS TO BE DONE AFTER THE RIDE
LIST OF THE TASKS AFTER THE RIDE
1. Tilt the JetSurf Electric so that the cooling water outlet is oriented down-
wards and let all the water out.
2. Check whether there is water at the bottom of the motor compartment . ( p. 43)
3. Check for water presence in the ventilation system. ( p. 43)
4. Rinse the whole JetSurf with fresh water, including the battery com-
partment with battery pack cover on.
( p. 53)
5. Let the JetSurf Electric dry.
6. Lubricate the shaft bearings. ( p. 53)
7. Do not charge the battery before transportation.
8. Store the JetSurf with the battery removed.
9.12.2. GETTING THE REMAINING WATER OUT OF THE COOLING SYSTEM
• After the ride is nished, you have to turn
the board 90° sideways and wait for a while
until most of the water gets out of the
cooling water outlet
• Then place the board on the stand.
Info
In this way you will remove the remaining water from the cooling system of the JetSurf
Electric.
JE_0908
JE_0909
To Next Page
Loading...
