39
8. BEFORE THE RIDE
• Grasp the opposite ends of the two rods
which are less distant from the clamp of the
stand and pull them apart.
• In the end turn the stand 180° so that the
ends of the bards
B
, covered with rubber
were oriented upwards.
Note
Make sure the stand is placed on a solid surface and that the motorised surf is placed
correctly on the stand. .
8.3. FINS
Every JetSurf Electric is supplied together with 3 (three) ns - 2 (two) small side ones and one
(1) big main one.
8.3.1. FASTENING OF SIDE (SMALL) FINS
• Insert the n in the plug and place the front
tab of the n inside the front slot of the plug
so that the hook in the n tabs hits the hori-
zontal bar in the groove.
B
B
JE_0807
JE_0808
JE_0809
To Next Page
Loading...
