JETSURF ELECTRIC - 9.3. Brief Description of Starting

47
9. RIDING INSTRUCTIONS
9.3. BRIEF DESCRIPTION OF STARTING
Caution
The rider prepared to use the JetSurf Electric must wear a life jacket, safety helmet and
must have the original JetSurf wrist band with the engine shut-o key attached to his/
her wrist and it must be connected with the motorized motorized board by means of
the safety leash.
For sharp start from water it is necessary to nd a suitable place where to start riding.
First it is necessary to have a sucient depth from which we can start safely without
damaging the bottom ns of the motorized surf.
Note
The minimum depth is 50 cm. Keep in mind that after starting the engine, the rear part
of the board may sink by 10-20 cm.
Warning (Risk of Accidents)
• Never start JetSurf Electric in swimming area.
• Make sure that you have sucient space for manoeuvring, mainly if you are a
beginner. The ideal area is 300x300 m without obstacles and with smooth water
surface.
• Always check water (the dirt and litter in the water) to avoid damage of JetSurf
Electric.
1. STAGE ONE
Inserting the shut-o key into the shut o switcht
for 5 seconds
- - -
Removing the shut-o key from the shut-o switch
1. The ECU waits 5 minutes for
the second key insertion
2. The indicator ashes blue
2. STAGE TWO
Second insertion of the shut-o key into the shut-
-o switch
1. Indicator lights violet - diagnostics
2. Activation of driving mode
3. Indication of battery pack
capacity