37
8. BEFORE THE RIDE
• Insert the rod in the groove in the stand
support so that the rubber end of the bar is
oriented upwards and secure the bar with
a screw.
Info
When assembling the stand, it is necessary to pay attention to the correct orientation
of the base and ends of the bars (see gure JE_0804) so that the correct function is
ensured.
• Tighten the screw.
Tightening torque 3,5 N.m
Info
The screw should be tightened using the Allen key supplied with the JetSurf Electric.
• This procedure is repeated for the other 3
(three) rods.
JE_0802
JE_0803
JE_0804
To Next Page
Loading...
