93
5.5.4.5-12
5.5.5-2
5.5.4.5-11
5.5.5-1
5.5.4.5-13
5.5.5 Performing a compensation run
All clamping and centering means are balanced in our
works to within a certain tolerance.
To compensate for any residual unbalance that might
be left in the clamping means, it is recommended that
an electrical compensation run be performed after
switching on the machine or after changing the wheel
adapter, especially a motorcycle wheel adapter. This
mode cannot be transferred into the permanent
memory.
• Starting from the screen main menu (Fig. 5.5.5-1)
press the menu key F2 for electrical compensation
of unbalance in clamping means (1, Fig. 5.5.5-1).
• Start the compensation run with the START key.
The compensation run takes longer than a regular
measuring run. After the compensation run the
pictograph = 0 showing that compensation has been
carried out appears above menu key F1.
This mode of operation is retained until deleted by
pressing menu key F2 (Fig. 5.5.5-2) again, by starting
readjustment or an optimization run, or by switching
off the machine.
1
To Next Page
Loading...
