118
7.1 System messages.
The wheel balancer can show messages to the
operator. These may be error related (E-codes) or
service related (C-codes). The codes will be described
in the following chapters.
Whenever a code appears:
- note it down
- look up the code in the list. If the code is not
described, call service.
- perform the steps described.
The setup of this chapter is:
Code
Description
• Step(s) to be performed.
7.1.1. Error codes
Errors in operation - Error code E
Warnings - Error code H
Fatal error code - 300 or C10
E1
Rim dimensions were entered incorrectly, or
incompletely.
• When the error code is read out, enter data once
again.
E2
Wheel guard is not closed.
E3
Gauge arm for distance and rim diameter is not in home
position.
E5
Range of electrical compensation exceeded (wheel
adapter has unacceptable unbalance).
• Press STOP key.
• Check wheel adapter, repeat compensation run.
E6
The calibration weight was not fitted for readjustment.
• Press STOP key.
• Repeat readjustment.
E7
With this wheel type it is not possible to choose a
balancing mode.
• If necessary, choose another wheel type.
To Next Page
Loading...
