4
4.19 CHECK AND REPLACEMENT OF DIAMETER POTENTIOMETER PAG. 33
4.20 CHECK AND REPLACEMENT HOOD SWITCH PAG. 34
CHAPTER 5 TROUBLE SHOOTING PAG. 36
5.1 INTRODUCTION PAG. 36
5.2 TO UPDATE SOFTWARE PAG. 36
5.3 IN THE FIELD REPROGRAMMING OF BALANCERS PAG. 37
5.4 RECOMMENDED SERVICE STEPS PAG. 37
5.5 SELF TEST DURING STARTUP PAG. 37
5.6 “H” ERROR CODES PAG. 44
5.7 “E” ERROR CODES PAG. 45
5.8 ERROR CODES ON INTEGRATED IBP BOARD PAG. 56
5.8.1 STRUCTURE OF AN ERROR CODE PAG. 56
5.8.2 PRIORITY ID PAG. 56
5.8.3 ERROR ID PAG. 56
5.9 “K” CODES (KERNEL CODES) PAG. 60
5.9.1 STRUCTURE OF AN ERROR CODE PAG. 60
5.9.2 PRIORITY ID PAG. 60
5.9.3 ERROR ID PAG. 60
5.9.4 B- BEEPS OF THE INITIALISATION STEP PAG. 60
5.9.5 -C- BEEPS OF THE MODULE/OBJECT PAG. 61
5.9.6 -D- PAUSE BETWEEN THE CYCLES PAG. 61
CHAPTER 6 SERVICE CODES PAG. 62
6.1 INTRODUCTION PAG. 62
6.2 TABLE OF SERVICE CODES PAG. 62
6.3 ENTERING “C” CODES AND OPTION PAG. 63
6.4 SAVING SETTINGS FOR MODELS OF OPERATION AND
CALIBRATION DATA PAG. 63
6.5 USER “C” CODES REFERENCE PAG. 63
6.6 SERVICE “C” CODES REFERENCE PAG. 68
UPDATING GUIDE PAG. 90
To Next Page
Loading...