44
5.6 “H” ERROR CODES
H0 Optimisation Can't Improve
Press ESC button and balance the wheel again without perform the optimization because the whe-
el running conditions cannot be improved.
H1 Optimisation Not Recommended
Further optimization not recommended but feasible
H2 Optimisation Recommend Minimisation
Weight minimisation is recommended, optimisation can achieve no further improvement
H20 Sape Can't Relocate
Measure the correction plane and switch to dynamic unbalance reading.
H21 Sape Position Not Matched
Index the correct position for this correction plane prior to fi tting the adhesive weight.
H80 User Calibration Not Provised
Check if the calibration weight is attached.
If the problem still persists:
Check if the calibration weight is attached in the correct side.
If the problem still persists:
Check if the calibration weight is correct
H82 Selftest Disturbed
Turn the machine off and back on without touch the unit.
H90 Measuring Speed Not Reached
Check if the brake is released.
If the problem still persists:
Make sure that the shaft with clamped wheel can rotate freely: Repeat the measuring run.
H91 Measuring Speed Fluctuation
Check if the brake is released.
If the problem still persists:
Make sure that the shaft with clamped wheel can rotate freely: Repeat the measuring run
To Next Page
Loading...