3
TABLE OF CONTENTS
CHAPTER 1 INTRODUCTION PAG. 6
1.1 GENERAL PAG. 6
1.2 TOOLS REQUIRED PAG. 6
1.3 IMPORTANT SAFETY INSTRUCTION PAG. 8
1.4 ELECTRICAL SAFETY PRECAUTION PAG. 8
CHAPTER 2 AC/DC POWER DISTRIBUTION PAG. 9
2.1 LOCKOUT AND/OR TAGOUT SYSTEM PROCEDURE PAG. 9
2.2 ELECTRICAL REQUIREMENTS PAG. 9
2.3 AC THEORY OF OPERATION PAG. 9
2.4 DC THEORY OF OPERATION PAG. 10
2.5 FUNCTIONAL DESCRIPTION PAG. 10
2.6 INSTALLATION PRECAUTIONS (Floor Level) PAG. 11
CHAPTER 3 BALANCERS COMPONENTS PAG. 12
3.1 INTRODUCTION PAG. 12
3.2 INTEGRATED DISPLAY PANEL PAG. 12
3.3 POWER ENTRY MODULE PAG. 13
3.4 INTEGRATED IBP BOARD PAG. 13
3.5 CAPACITORS PAG. 13
3.6 KEYPAD PAG. 13
3.7 VPM VIBRATORY ASSEMBLY PAG. 14
3.8 TRANSDUCERS PAG. 14
3.9 TEMPERATURE SENSOR PAG. 15
3.10 INCREMENTAL ENCODER PAG. 15
3.11 ENCODER BOARD OF THE MAIN SHAFT PAG. 15
3.12 MOTOR DRIVE SYSTEM PAG. 16
3.13 BELT TENSION PAG. 17
3.14 BRAKING BY REVERSING THE MOTOR TORQUE PAG. 17
3.15 THE ELECTROMAGNETIC BRAKE PAG. 17
3.16 SD SAPE (SEMI AUTOMATIC PARAMETER ENTRY) PAG. 17
CHAPTER 4 SERVICE PAG. 18
4.1 INTRODUCTION PAG. 18
4.2 POWER SUPPLY CABLE : CHECK AND REPLACEMENT PAG. 18
4.3 TO ACCESS TO THE IBP BOX PAG. 18
4.4 CHECK POWER TO IBP BOX PAG. 19
4.5 CHECK AND REPLACEMENT POWER ENTRY MODULE PAG. 19
4.6 CHECK AND REPLACEMENT OF THE MAIN SWITCH PAG. 21
4.7 CHECK AND REPLACEMENT POWER ENTRY MODULE 6.3A FUSES PAG. 22
4.8 CHECK AND REPLACEMENT OF THE INTEGRATED BOARD F2 FUSE PAG. 22
4.9 CHECK OF THE POWER SUPPLY VOLTAGE PAG. 23
4.10 CHECK AND REPLACEMENT OF THE IBP BOX PAG. 24
4.11 CHECK THE VIBRATORY SYSTEM PAG. 25
4.12 REPLACEMENT OF THE VIBRATORY SYSTEM PAG. 25
4.13 CHECK AND REPLACEMENT OF TRANSDUCERS PAG. 26
4.14 CHECK AND REPLACEMENT OF ENCODER BOARD OF MAIN SHAFT PAG. 29
4.15 CHECK AND REPLACEMENT OF THE MOTOR PAG. 30
4.16 CHECK AND REPLACEMENT OF THE BELT PAG. 31
4.17 CHECK AND REPLACEMENT ELECTRIC/CLAMPING PEDAL SWITCH PAG. 31
4.18 CHECK AND REPLACEMENT DISTANCE POTENTIOMETER PAG. 32
To Next Page
Loading...