Engineering manual - SAB 355 Screw compressor unit (including ATEX)
004100 en 2020.10
107/156
Installation instructions
7.27 Auxiliary tools for coupling alignment
Four clamps with adjusting screws are delivered with each unit as shown in Fig. 76 as well as five
sets of liner plates, see Table 28.
No
Dimension
(mm)
2
2
3
2
2
0.10x120x110
0.15x120x110
0.25x120x110
1.00x120x110
3.00x120x110
Table 28: Liner plates
The screws which are supplied, see Fig. 75, are used for lifting large motors when inserting liner
plates. The clamps shown in Fig. 76 are used for sideways shifting of the motor.
Fig. 75: Auxiliary tools for coupling alignment 1
Fig. 76: Auxiliary tools for coupling alignment 2
Furthermore, an alignment tool and a feeler gauge are delivered for coupling alignment as shown
in Fig. 78.
To Next Page
Loading...
