Engineering manual - SAB 355 Screw compressor unit (including ATEX)
004100 en 2020.10
143/156
Transport instructions
14.5 Loading instructions
When unpacked, the unit can be lifted with a crane. The unit must be lifted in the lifting eyes on
the unit. Never lift in the lifting eyes on the compressor or the motor separately.
Fig. 88: Position of lifting eyes
As a minimum the lifting capacity of the crane and the loading capacity of the chains, straps, lift-
ing eyes and shackles must correspond to the weight of the unit + the weight of the electric
motor.
14.6 Preparations before lifting
Before lifting the unit, make sure that straps/chains are properly secured to lifting eyes/shackles
and that the lifting equipment is in good condition.
14.7 Loading
Be very careful not to damage the unit when loading it. Note in particular that the instrumentation
of the unit is very vulnerable to impacts.
14.8 Transport instructions
Danger!
Risk of injury to personnel and damage to equipment! Johnson Controls Denmark is not liable for
injury to personnel or damage to equipment caused by the use of transport methods which are
not recommended in this document or stated in a separate agreement between a transport com-
pany and Johnson Controls Denmark.
Additional lifting
points. Extra 6 pcs.
To Next Page
Loading...
