Engineering manual - SAB 355 Screw compressor unit (including ATEX)
12/156
004100 en 2020.10
Introduction
1.4 Amendments to the manual
2020.10 Version 3
• Subsection 4.1.31 KRACHT oil pump has been revised.
• Subsection 4.1.32 Economiser, high-stage (optional) has been revised.
• Subsection 7.25 VSD equipment has been revised.
• Subsection 7.29 Alignment procedure for coupling has been revised.
• Various minor corrections.
2019.11 Version 2
• Description of new KRACHT oil pump, see subsection 4.1.31.
• Updated general piping diagram, subsection 4.1.34.
• New compressor name plates, subsections 2.3 and 2.4.
• Minor corrections.
2018.08 Version 1
• This version replaces revision 2011.08.
• Many sections of the manual have been changed, for example:
• Name plates with EurAsian Conformity mark (EAC) have been added.
• ‘Requirements for competent persons’ section has been added.
• ‘Compressor port locations’ section in chapter 6. has been updated.
• ‘F-gas regulation’ section has been updated.
• Noise data: Add 2 dBA to the values for 60 Hz compressors (used to be 3).
• The ‘Storage’ section in the ‘Transport instructions’ chapter has been revised.
• ATEX instructions have been included.
• European units of measurement have been added in various tables.
• And more.
1.5 Manufacturer's information
This manual is produced by:
Johnson Controls Denmark ApS
Christian X's Vej 201
8270 Højbjerg, Denmark
Phone +45 87 36 70 00
CVR No 19 05 61 71
www.sabroe.com
Copyright © Johnson Controls Denmark
This manual must not be copied without the written permission of Johnson Controls Denmark,
and the contents must not be imparted to a third party nor be used for any unauthorised purpo-
ses. Contravention will be prosecuted.
To Next Page
Loading...
