Johnson Controls SAB 355 - List of Components

Engineering manual - SAB 355 Screw compressor unit (including ATEX)
004100 en 2020.10
81/156
Physical and connection data
Fig. 59: Position of valves and components
5.2.3 List of components
151 TE1 Suction gas temperature
152 TE2 Discharge gas temperature
153 TE3
Oil temperature
154 TE4
Separator oil temperature
155 PE1
Oil pressure
156 PE2
Oil filter before pressure
157 PE3
Discharge pressure
158
PE4 Suction pressure
159 PS
Pressure switch control
160 LSLL
Low level shutdown
161 HTR 1 Heater
162 HTR 2
Heater
ZI2
Capacity linear transmitter, slide valve
ZI3
Volumizer transmitter - slide stop
YY-1
Energise unload slide valve
YY-2
Energise increase volume rate
YY-3
Energise increase volume ratio
YY-4
Energise decrease volume ratio
EC
UniSAB III electronic control system
Motor, pos. M
Connection data for supply voltage:
VAC
Permissible variation: +10%/-15%
Frequency: 45-65 Hz
Power:
kW
Supply voltage and motor power appear from the order sheet.
155
153
YY1-4
ZI2
ZI3
PE2