Johnson Controls SAB 355 - Identification of Johnson Controls Denmark Equipment

Engineering manual - SAB 355 Screw compressor unit (including ATEX)
004100 en 2020.10
15/156
Signs and warnings
2.2 Identification of Johnson Controls Denmark equipment
All Johnson Controls Denmark equipment can be identified by one or several name plates placed
as illustrated in the following drawing:
Fig. 1
1. Compressor name plate
2. Vessel name plate
3. Unit pipe system name plate
Components placed high above the ground, the POV relief valve system and the suction strainer
with stop valve are dismounted and blanked off for transportation purposes. Each system is
marked with a name plate identical to the unit pipe system name plate, pos. 3.
When mounting the systems, check the identity and remove the name plates from the POV relief
valve system and the suction strainer with stop valve, and discard them.
3
2
1