Engineering manual - SAB 355 Screw compressor unit (including ATEX)
004100 en 2020.10
73/156
Technical description
4.1.36 Instrumentation
The screw compressor unit can be controlled by UniSAB III control system which is mounted on
the unit and connected to a number of temperature and pressure sensors on the unit.
The UniSAB III control system is described in a separate manual.
Fig. 53 and Fig. 54 show the positions of sensors, valves, etc.
See also the general piping diagram in this section, Fig. 52.
The numbers refer to 4.1.33 General key to piping diagram.
Fig. 53
122135119139 136194140149144 123
121
137
138
105
104
146
124
125102107
126
103108
To Next Page
Loading...
