JOHNSON CONTROLS
72
FORM 160.54-O1
LD12573
OVERVIEW
This screen displays all information pertinent to the
Medium Voltage Solid State Starter (MVSSS). Soft-
ware version C.OPT.01.15.307 (or later) is required for
MVSSS applications.
DISPLAY ONLY
Motor Run (LED)
Indicates when the Optiview Control Center is com-
manding the motor to run.
Motor Current % Full Load Amps
Displays the motor current as a percentage of Job Full
Load Amps setpoint.
Current Limit Setpoint
Displays the Current Limit in use. This value could come
from a 0-20mA, 4-20mA, 0-10VDC or 2-10VDC input
in Analog Remote mode, PWM signal in Digital Remote
mode, Microgateway interface in ISN Remote mode or
a locally programmed value in Local mode.
MEDIUM VOLTAGE SOLID STATE STARTER SCREEN
FIG. 18A
Pulldown Time Left
Displays the time remaining in the programmed
pulldown period.
Input Power
Displays the kilowatts measured by and transmitted
from the starter.
KW Hours
Displays the cumulative kilowatt hours. The microboard
calculates this value from the Input Power transmitted
from the starter. When the number exceeds 999999
KWH, the value will rollover to zero.
Voltage – Phase A, B, C
Displays the 3-phase input line voltage as measured by
and transmitted from the starter.
Current – Phase A, B, C
Displays the 3-phase motor current as measured by and
transmitted from the starter.
Starter Model
Displays the starter model number as transmitted from
the starter.
OptiView Control Center
To Next Page
Loading...
