Johnston VT501 - Page 10

All Copyright and rights are the property of Johnston Sweepers Ltd
V Range 501 l 651 l 801 Maintenance Manual
MA1:6
Chapter - Scheduled Maintenance
Area Remove / Ret Time Taken
(Mins)
Special Tools
Required
1 or 2
Persons
Sweepgear Channel Brush position ram (Includes
check and top up hydraulic oil)
30 None
1
Sweepgear Channel brush curtain (each) 10 None
1
Sweepgear Channel brush kick back fork (Includes
replacement of spring)
20 None
1
Sweepgear Channel brush lift ram 15 None
1
Sweepgear Channel brush motor (with brush and
brush plate removed). Includes check
and top up of hydraulic oil
25 None
1
Sweepgear Channel brush motor mounting (with
motor, brush and brush plate removed)
10 None
1
Sweepgear Brush plate (with brush removed) 10 None
1
Sweepgear Brush head 10 None
1
Sweepgear Nozzle assembly 30 None
1
Sweepgear Nozzle carriage (Nozzle assembly
removed)
15 None
1
Sweepgear Nozzle rubbers 30 None
1
Sweepgear Nozzle water jets (low pressure) 15 None
1
Sweepgear Nozzle tow bar (With tow eye removed) 25 None
1
Sweepgear Nozzle tow eye 10 None
1
Sweepgear Nozzle box lift cylinder (each) 15 None
1
Sweepgear Maxi gap cylinder 15 None
1
Sweepgear Carriage wheel (Includes remove and
ret auto lube pipe)
10 None
1
Sweepgear Nozzle box bumper 10 None
1
Sweepgear Trunking 10 None
1
Wide Sweep
Brush
WSB Assembly (Dual and single ma-
chines )
90 None
1
Wide Sweep
Brush
Brushes (Replace) 30 None
1
Wide Sweep
Brush
Tow bar (Includes removal and retting
of WSB and brushes)
40 None
1
Wide Sweep
Brush
Tow bar compensator (Includes
removal and retting of WSB, brushes
and tow bar)
45 None
1
Wide Sweep
Brush
Brush motor (Includes removal and
retting of brushes)
75 None 1
Used oils and filters should be disposed of in accordance with the local
waste disposal regulations.
These procedures should be carried out by qualified service personnel.
This Guide Detail the time taken to remove, ret and validate the item listed. Where the task is listed as 2
person the total time taken is shown in the table however certain aspects of the tasks may require 2 persons
for the safe completion of the task.
Page Issue B