All Copyright and rights are the property of Johnston Sweepers Ltd
MA10:3
V Range 501 l 651 l 801 Maintenance Manual
Johnston Sweepers Limited
Chapter - Health and Safety
Jump starting procedure:
Always follow this procedure when connecting a booster battery.
Take care not to cause sparking which could ignite hydrogen gas being given off by the
batteries.
1. Apply the park brake, turn off ignition, lights and other electrical loads.
2. If the slave battery is mounted on another vehicle, ensure that the vehicles are not
touching.
3. Ensure that the donor battery voltage is compatible with the vehicle battery.
4. Ensure that adequate ventilation is available to the vehicle and slave batteries.
5. Connect positive terminal of the donor battery group to positive terminal of the
discharged battery group.
6. Connect negative terminal or slave battery group to chassis earth of the discharged
battery group.
7. Attempt to start the casualty vehicle.
8. Once the vehicle has started, remove the negative lead from the chassis and then the
slave battery.
9. Remove positive lead from discharged chassis and then the donor chassis.
If the vehicle will not start with a booster battery, contact your local Johnston Service Network.
Chemical materials:
Chemical materials such as solvents, sealers, adhesive, paints, resin foams, battery acids,
anti-freezes, brake fluids, oils and grease should always be used with caution and stored and
handled with care.
Chemical materials may be toxic, harmful, corrosive, irritant or highly flammable and give rise
to hazardous fumes and dust.
Always consult the appropriate safety standards for handling such materials.
Typical biohazard symbol
Typical radioactive material symbol
Typical poison symbol
Always use appropriate protective clothing
Page Issue A
To Next Page
Loading...
