DP321 User's Manual
- 29 -
Set the font for the printer to use in the absence of any font control instructions from your software.
5. ENG PITCH
Set the pitch to determine the horizontal spacing of the printed English.
6. CHI PITCH
Set the pitch to determine the horizontal spacing of the printed Chinese.
7. INTL CHAR SET
Select international character.
8. CHARACTER SET
Select character set into Italic Character Table or Graphic Character Table.
9. IBM CHAR TBL
Select SET 1 or SET 2 character table.
10. CODE PAGE
Select a code page.
11. LINE SPACING
Set the vertical spacing of the printed characters. You can set it to either 6 LPI (the default setting) or
8 LPI.
12. FORM LENGTH
You can set the page length to 3, 3.5, 11/3, 4, 5, 5.5, 6, 7, 8.5, 11, 12, or 70/6 (the length of A4 paper)
inches.
13. FORM LOCK
Pages long setup instructions invalid.
14. PAGE SKIP
When this function is set valid, the printer will leap over the page skip during printing, it will leave a
one inch margin in the bottom of the current page and the top of the next page. Most of the software
will set the margin at the top and bottom of the page itself, so you just use this function when the
software doesn’t offer this margin. This function is unvalid for cut-sheets.
15. COMPRESS PRINT
Select compressed print mode or normal print mode.
16. PRINT DIR
Print direction mode contains one-way、bidirectional and automatic mode. When default option is
automatic mode, print direction is bidirectional. Only choosing “automatic mode”, print direction
instruction is in effect. If choosing “one-way” or “bidirectional” mode, print direction instruction is
invalid.
17. PRT-SPEED
Select printing speed.
18. AUTO LF
When this function is on, each carriage will advance one line of the page. If you don’t want your fonts
with double spacing, select this function “OFF”; if the printed content are superposed, you should
turn this function on.
To Next Page
Loading...
