22
5.5.1 Running Speed Setting (L1)
Users may adjust the gate opening/closing speed according to the actual installation and using
condition.
A. Operation Instruction:
1. Press and hold “PROG” button for 3 sec. to enter into basic menu. Indicator light L0 will flicker
once, then L1 will be always on.
2. Press “SET” button once to enter into running speed setting. Indicator lights L1-L5 will show
the current running speed. (The default is L3)
3. Press “+” or “-” button to adjust the running speed. Indicator lights L1-L5 will indicate different
speed status. The more the indicator lights will be on, the faster the running speed will be.
4. Press “SET” button to save and automatically exit. The indicator lights L1-L5 will be on for one
sec.
B. Operation Graphic Illustration
SET
Press “SET” button once
LED
Press “+” or “—” button to adjust the
parameters, LED will show the
Press “PROG” button for 3 sec
LED
PROG
L0 flicker once, L1 will be on
SET
Press “SET” button once
LED
L1-L5 will be on for one sec
Save and exit automatically
corresponding value.
Figure 24
To Next Page
Loading...
