V
alues
Using the SEL key
, move the cursor to the left of the master
channel. Press the left or right CH keys to position the cursor
below the master or slave channel. Press the + or - keys to select
the desired channels.
Operating with a Switch
Pressing the SEL key
, position the cursor to the side of SW
: and
using the + or - keys select the desired switch for the par
ticular
program mix being used. Refer to figure 4
.1
3B.
Position the cursor to the left of “Point” and press the left or right
CH keys to reverse the position point. Increase or decrease the
mixing value using the + or - keys or the CLR key
. When you
wish to reverse the mixing direction, press the - key to increase
the minus value to the desired position. T
o activate point 1 or 3
with “INH” displayed, press the + or - key at that position to
display mixing value. Press the CLR key if you want to inhibit
mixing. Mixing value “0” can be set at points L, 2, and H by
pressing the CLR key
.
To Next Page
Loading...
