JR XP810-3 - Page 76

www.modelflight.com.au – World’s best source of JR products
4 . 5 T ravel Ad
j
ust
(
Function Mode
)
The purpose of T ravel Adjust, also known as endpoint
adjustment or adjustable travel volume, is to offer you precise
ser vo control deflection in either direction of ser vo operation.
The travel adjust range is from 0-1 5 0% (0 degrees to 6 0
degrees) from neutral and it can be adjusted for each direction
individually
. The factor y default (data reset) value is 1 00% for
each direction of servo travel.
In the Function Mode, use the UP or DN key to select the T ravel
A
djust function and access by pressing the UP and DN keys
simultaneously .
Channel being programmed
THRO Throttle
AILE
Aileron
ELEV
Elevator
RUDD
Rudder
GEAR
Channel 5
PITCH Pitch/Aux 1
AUX2 Aux 2
A
UX3 Aux 3
Press the UP and DN keys
simultaneously to enter/exit
the Function Mode
Press the DN and Select key
s
simultaneously to access th
e
Function Mode List Dis
p
la
y
To Stunt Trim
UP
DN SELECT CH CH CLEAR
Reset travel
function
To Sub- Trim
function
Press to display
channels 1-4 and
5-8
(
2 screens
)
Channel
Selection
Press to increase or
decrease travel value;
move stick or switch to
manipualte arrow to the
position to be adjusted
(
hi
g
h/low, left/ri
g
ht
)
value to factory
p
reset
(
100%
)
4 . 6 Stunt
T
rim
(
Function Mode
)
The Stunt T rim Function is a trim position setting for aileron,
elevator and rudder for use during for ward flight maneuvers. This
function is activated when in the flight modes 1 and 2 .
Note: When this function is activated, the trim levers of the
aileron, elevator and rudder are inactive. Maximum adjustment
range is approximately 3 0 degrees.
T o adjust the stunt trim, fly your helicopter in a straight line at full
throttle/pitch in flight mode 1 or 2 . Center the elevator stick.
Note which direction the helicopter pitches. If the helicopter
pitches up, land the model and add down stunt trim. Repeat
until no pitching occurs.
Next, check the rudder . Add rudder stunt trim until the tail tracks
directly behind the helicopter. Finally , adjust the aileron stunt trim
in the same manner until no rolling occurs. When properly
adjusted, your helicopter will fly straight and level at full speed
with no correction or trim required.
In Function Mode, use the UP and DN keys to select Stunt T rim
and access by pressing the UP and DN keys simultaneously .
Initail setting
(
inhibit
)
Press either + or - key to
activate and
Increase/Decrease value
CLEAR
Press CLR key to reset value
(at arrow) to zero or to inhibit
stunt trim function
Arrow indicates channel
to be adjusted
Stunt Trim
V
alue
(max ± 125)
HELI 76